Pure Polyurea Coatings

Polyurea is a technology where an extremely tolerant and fast-setting coating is created by adjusting properties of two reactive components. Curing takes place within seconds rather than minutes. Due to its toughness and elasticity, it’s one of the most resisting coatings on the planet.

TEKNOPUR 300 elastomeric coating

Teknos’ pure polyurea coating known as TEKNOPUR 300 is intended for areas where high levels of mechanical protection and total waterproofing are needed. TEKNOPUR 300 contains no solvents and is not classed as flammable.

TEKNOPUR 300 elastomeric coating can be applied in layers up to 5 mm thick which combine excellent sealing properties with high levels of mechanical durability. Special two-component equipment is needed to apply the coating, which heats it to around 80°C. The fastest curing versions have a gel time of 4 seconds and a walk-on time of around 40 seconds.

Polyurea is typically used as a floor or roof covering and also in other areas where protection against water, chemicals and heavy wear is needed.

EXTREMELY FAST CURING

Polyurea is a technology where an extremely tolerant and fastsetting coating is created by adjusting properties of two reactive components. Curing takes place within seconds rather than minutes.

ONE OF THE MOST RESISTANT COATINGS IN THE WORLD

Due to its toughness and elasticity, TEKNOPUR 300 withstands high abrasion, impacts and extreme mechanical loads. It also creates a seamless waterproof film that gives matchless protection to the surface beneath the coating. TEKNOPUR 300 is highly resistant to corrosion and chemicals. When it comes to operational temperatures, TEKNOPUR 300 offers a wide temperature area. Typical usage temperatures are from 40 degrees below zero up to +150 degrees C.

ENVIRONMENTALLY FRIENDLY

Solvent-free TEKNOPUR 300 emits no volatile organic compounds and therefore it is an environmentally friendly choice as well

TRADITIONAL EPOXY COATING AND TEKNOPUR 300
AFTER IMPACT RESISTANCE TEST AT -20°C.

Suitable for industries and objects

  • Mining industry

  • Pipelines

  • Secondary containment

  • Machines

  • Transportation vehicles

  • Roofs

  • Steel structures

  • Concrete structures

  • Pools

TEKNOPUR 300 elastomeric coating’s high level of mechanical strength makes it the ideal solution for protecting blasting machines from wear and it can replace the rubber matting that is widely used for this purpose.

Where it is applied to the inside of glass recycling containers, it also provides noise insulation. This is a very welcome development for people living near the recycling site, because the noise of the glass can be irritating.

The coating is also highly resistant to chemicals, which opens up a wide range of applications, including storage and pre-treatment tanks, chemical containers etc.

Extremely fast curing – curing within seconds!

Walkable within less than a minute.

  • 12 sec - Tack-free

  • 40 sec - Walk-over time

  • 24 hours - Fully cured

  • 1-3 days - Immersion tolerant

Suitable for immersion and waterproofing

  • Excellent adhesion to metal and concrete.
  • Seamless waterproof film.
  • Excellent crack bridging ability.

Fast and efficient coating process!

Operator and environmentally friendly

  • Zero VOC emissions
  • No need for hot work license (roofing)
  • No flammable compounds during application and curing
  • Fire classification of TEKNOPUR 300:
    EN 13501-1: Efl
  • Fire classification of TEKNOPUR 340 FR:
    CEN TS 1187: BROOF T2
    EN 13501-1: Cfl-s1

Read more: www.teknos.com/industrial-coatings/special-applications/polyurea-technology

Would you like more information or offer?

Contact our experts!

Watch a video about our polyurea technology!